That was fun…we need to do something like this again. :)

So this is going down this evening…:)

I might be getting somewhat back into shape:

What’s this turdburglar doing as the spokesrat for shredding the Second Amendment? He wasn’t even at the school when the shooting occurred. The Lügenpresse has passed him off as a survivor. The only thing he’s survived is his mother not deciding to go see the abortionist:

The motherlode of Attention Hogg memes: https://westernrifleshooters.wordpress.com/2018/03/26/codrea-demeanor-of-march-for-our-lives-student-leaders-could-be-movements-achilles-heel/

One of the tamer ones included below.

Only slightly photoshopped (not by me…I received it this way). These goons make it too easy:

Time-lapse video of a spool bolt and nut being printed. Frames were shot 10 seconds apart, so at 25 fps, each second covers 4:10 of build time. It takes about two and a half minutes to cover a 10-hour-plus job.

Added a camera to the printer so I can see what it’s doing when I’m away…useful while it’s still at the office. Since the office lights switch off automatically, there’s a cheap table lamp keeping it lit until I rig it with LED strip lighting. It’ll send low-framerate (5 fps) live video, and it can produce time-lapse video of a printing session.

Something I definitely need to make, though: a tool to focus the lens.

(Right now, it’s printing a filament-spool bolt and nut. With them, filament should pay out more easily. Right now, the spool is spinning around a length of M8 threaded rod.)